4.5 mm thickness Anti Static PVC Flooring 600 * 600 * 4.5mm
Type of Flooring: anti-static vinyl floor tile
600 mm X 600 mm X 4.5 mm
(special run for 24” x 24”)
Total thickness: 4.5 mm
- Anti-static vinyl wear layer = 1.0 mm
- Multiple layers vinyl backing = 3.5 mm
Total weight per sq. meter: 8.0 kg
Surface resistively: 106 ~ 109 ohms (ASTM D257)
Electrostatic propensity: less than 0.6 kV (AATCC 134-01)
Fire index: Class 1 (NFPA 253 / ASTM E-648)
Dimension stability: < 0.15% (Aachen Dimensional Stability
Taber wear test: less than 0.007 mm loss (500 cycles - ASTM D4060)
Chemical resistance: no change (24 hours ratings ASTM F925-02)
Static Load: < 2.0% compression (ASTM F970-00 static load limit
Color: 8 standard colors
Special run color: minimum 500 sq. meters
Packing: 8 pieces per box
Color variation: Colors may vary due to different production lot.
- To maintain anti-static property, do not apply oil-base wax.
- Sand and alien materials should be removed. They may cause damage.
Keeping floor clean is necessary in order to maintain steady
- Clean contaminated floor surface by mild detergent. The detergent
should be removed by wiping with wet mop. Rinse at least twice with
- Waxing: use water-base emulsion wax. Waxing after floor clean and
Warranty: limited 5 years warranty.
Product improvement: In order to pursue product improvement, the
manufacturer reserves the right to change specifications without
(1)the requirements of foundation
1.The ground should be waterstone ground, caramic tile groud,
wooden ground or cement ground.
2.The ground should be smooth and level.Its unflatness should be
less than 0.2%.
3.The ground should have enough strength and no the phenomenon of
sand comimg out and separation.
4.The ground should be dry.It is necessary for a new ground to dry
(2)Procedure of construction
Clean the ground→spread the earthing conductive net→lead out the
earthing line→coat strong adhesive→coat conductive adhesive→lay
floor→welding floor→cleaning→inspect properties
(3)Maintenance of floor
1.It is not permitted that sharp and rough heavy matters scribe and
drag on the surface of floor and that personnel who wear shoes with
nails walk on the floor.The floor should be kept cleaning.
2.It is not permitted that the chairs which have black rubber
cushion put on the floor in order to avoid black sulfied polluting
3.If there are oil or dirty on its surface, it may be cleaned with
detergent.If there is scribed sign, if can be recovered through
fine abrasive paper.
4.If there are heavy oil and dirty caused by install equipments.Our
factory has special washer to clean them.
5.Our factory also has anti-static wax that can be used to maintain
the floor.In general, it should be coated one time every six
months.If the personnel walking on the floor are busy, it should it
should be coated every three months.